Nano-Fusion is available only as a clear film.

The film must be applied wet. Contact us for application Instructions and additional information.

Once the film is applied refrain from washing the vehicle in an automated car wash for at least 48 hours. Washing after that time presents no problem, and regularly applying a coat of wax is recommended.

Contact us for Installation Instructions.

Yes. When waxing the vehicle, some wax may build up along the film edges. This can easily be removed when dry with a soft brush such as an old toothbrush. Do not use any waxes containing dyes or waxes that are not recommended for urethanes. Abrasive polishes and/or rubbing compounds are not to be used.

If the film is properly applied to a fully cured painted vehicle, it can be removed, usually in one piece, without damaging paint surfaces beneath the film.

If desired, Nano-Fusion can be removed at any time by picking up a corner of the film and pulling the film off the vehicle surface from a 30 to 90-degree angle. If the film has been present a long time, or if the film and vehicle are cold, a heat gun or hair dryer may be used to soften the adhesive, allowing easier removal. If any adhesive remains on the vehicle after removal of the film, it can be removed by using Adhesive Cleaner according to the package directions.

We recommend that any repainted surfaces on your vehicle be professionally painted and fully cured before applying paint protection film. If you have touched up scratches or chips with a tube of “touch-up” paint and then apply paint protection film over it, the film will protect that area until it is removed. If the paint protection film is removed, it is possible that the area around the non-professional touch-up paint could peel off.

Though the film is repositionable during installation, once the application is completed and the adhesive sets, the film is not able to be removed and reapplied.

Most vinyl film plotters will work.

Basic tools include squeegees, spray bottles, towels, and heat guns, but for comprehensive instruction, we highly recommend you attend an installer certification-training seminar.

Attend our next training seminar. Simply fill out our contact form and we will email you our training schedule.

Attend one of our training classes or contact us for information on our next training class.

Yes. Contact your local distributor for literature.

We have master distributors throughout the United States that sell Nano- Fusion in bulk rolls or pre-cut kits.

Widths (in inches): 6, 12, 18, 24, 30, 36, 48 and 60. Lengths (in feet): 50 and 100.

We currently offer a comprehensive warranty. Please see our warranty section for full details.